Connector Contact Insertion

Step 1:
Grasp crimped contact approximately one inch behind the contact barrel.
Step 2: Hold connector with rear grommet facing you.
Step 3: Push contact straight into connector grommet until a click is felt. A slight tug will confirm that it is properly locked in place.
Step 4: Once all contacts are in place, insert green wedge. The green wedge will snap into place.

Connector Contact Removal

Step 1: Remove green wedge using needlenose pliers to pull wedge straight out.
Step 2: To remove the contacts, gently pull wire backwards, while at the same time releasing the locking finger by moving it away from the contact with a screwdriver.
Step 3: Hold the rear seal in place, as removing the contact will displace the seal.