Page 254 - IS-Rayfast Catalogue - Issue 9, 2017
P. 254

Terminals and Splices
      CWT / B155 / D1xx Series
      SolderSleeve ®
      Wire Termination to Pin, Post & Tabs

  1   Used for discrete terminating of wires to
      component terminals, such as motor tabs,
      connector pins or switch terminals.
  2
      Features & Benefits
       •  Transparent insulation sleeve provides
  3      encapsulation, strain relief and insulation
         with inspectability.
       •  Pre-fluxed solder preform provides                                      Only B155-150X RoHS compliant
  4
         controlled soldering process.
       •  One-piece design provides easy
         installation and low installed cost.  RoHS
  5                                        compliant
       •  A tape carrier option provides convenience
         and ease of installation.
  6    •  UL and CUL recognised.            Specifications & Approvals
                                             •  UL and CUL E87681
                                             •  D-5023 and RT-1404
  7                                          •  B-155 series RoHS compliant


  8    Material
       Insulation for D-129 and D-141  Radiation crosslinked, heat-shrinkable polyvinylidene fluoride
       Insulation for CWT and B155 Series  Radiation crosslinked, heat-shrinkable polyolefin
  9
       Solder and flux for D-129 and D-141  Sn63 Pb37                    Flux: ROM 1 per ANSI-J-004 [RMA flux]
       Solder and flux for B155     Sn42Bi58                      Flux: ROM 1 per ANSI-J-004 [RA flux]
  10   Solder and flux for CWT-1500 Series  Sn50 Pb32 Cd18          Flux: ROM 1 per ANSI-J-004 [RA flux]

  11   Typical Performance
       Temperature rating for CWT / B155 Series  -55ºC to +125ºC
  12   Temperature rating for D-129 and D-141  -55ºC to +150ºC
       Voltage drop                 2.0 mV
       Tensile strength             Exceeds strength of conductor
  13
       Dielectric strength          2.0 kV
       Insulation resistance        1000 M ohms
  14

                                                                Solder ring
  15

  16
                                                                    Pin, Post or Tab
  17

      Notes:
  18   •  Heat guns are recommended for the installation of these devices: HL2010E and CV198X with the correct
         reflector added. See Application Equipment Section.


    252            sales@is-rayfast.com  |  +44(0)1793 616700
   249   250   251   252   253   254   255   256   257   258   259