Page 270 - IS-Rayfast Catalogue - Issue 9, 2017

Terminals and Splices
PCB Coaxial Termination
SolderSleeve ®
Heat Shrinkable, termination

1 Used for the termination of coaxial cable to
printed circuit boards.
2 Features & Benefits
• Provides a completely shielded, low-
resistance, matched-impedance
3 termination with a very low Voltage
Standing Wave Ratio (D-607 series).
• Polyvinylidene fluoride or polyolefin
4
insulation sleeve provides encapsulation,
inspectability, strain relief and insulation.
• Pre-fluxed solder preform provides
5
controlled soldering process.
• One piece design provides easy
6 installation and lower installed costs. Specifications & Approvals
• Pre-installed termination body provides • TE Connectivity RT-1404
convenience and ease of installation.
7
Product Options
8 Product Series Typical Application Performance Shield Method Part Selection Table
D-607 Matched impedance up to 2.3 GHz Metal body A
9 B-046 Effective transmission up to 100 MHz Pin to ground B

10
Product Selection Process
A B C D
1 Select product series from the Product
Options table above.
11
2 Determine cable RG number or outside
diameter dimensions.
12 3 Select the appropriate part number from
Table A (D-607 series) or Table B (B-046
series).
13 • For D-607 (matched impedance) series,
determine straight or right angle entry
to PCB and grid pattern, then select the
14 appropriate part number from Table A on
the next page.
15 • For B-046 (PinPak, or pin to ground)
series, determine hole spacing and
diameter. Refer to Table B for product
16 selection (see illustration right for cable
dimensions).
17

Notes:
18 • Heat guns are recommended for the installation of these devices: HL2010E and CV198X with the correct
reflector added. See Application Equipment Section.

268 sales@is-rayfast.com | +44(0)1793 616700