Page 248 - IS-Rayfast Catalogue - Issue 9, 2017
P. 248

Terminals and Splices
      B-106 Series
      DuraSeal ®
      Heat Shrinkable, Crimp Terminals

  1   Crimp and Shrink
      DuraSeal products insulate and protect
      electrical connections for numerous
  2
      applications including;
       •  OEM wire harness fabrication
  3    •  Marine electronics
       •  Fleet maintenance
       •  Commercial wiring
  4
      Features & Benefits
       •  Resistance to moisture and abrasion.  RoHS
  5    •  Strain relief.                   compliant
       •  Protection from wire pull-out.
       •  Easy installation.                Specifications & Approvals
  6    •  Environmental protection.          •  UL and CUL 91J4, File E87681
       •  Colour coded for identification.   •  Lloyds listed, File 65 247 HH 02-93
       •  Transparent for inspection.        •  UL & CUL E157833 (for B106-3 & B106-4
  7
       •  Adhesive lined.                       series only)
  8    Product Characteristics        Product Performance
       Operating temperature          -55ºC to +125ºC
  9    Minimum shrink temperature     180ºC
       Cut through resistance         31.7kg
       Wire pull out after crimping and recovery  Red: 11.3 kg; Blue: 22.7 kg; Yellow: 27.2 kg
  10
       Chemical to ASTM D 3032, ESA-603D  Diesel fuel; Brake fluid; Antifreeze; 5% salt water; Motor oil
       Chemical resistance            Isopropyl alcohol, trichloroethane, gasoline, battery acid
  11
       Dielectric withstand           2500V
       Insulation resistance          10 Mega-ohms
  12
       Voltage rating                 600 Volt max
       Physical properties            Tensile strength exceeds strength of spliced wire
  13
      Product Installation Process                 Apply   Crimp     Heat
       1  Select appropriate size crimp to suit application.
  14     For terminal and disconnect terminations, strip
         wire insulation to expose 6.5mm conductor.
       2  Securely crimp using AD-1522 crimp tool for
  15     pre-insulated crimps.
       3  Heat terminal or disconnect with appropriate
         heat gun and reflector until tubing recovers
         and adhesive flows. Avoid heating ring or fork
  16
         metallic parts.
  17
      Notes:
       •  The correct crimp tool AD-1522, must be used for proper installation of these devices.
  18   •  Heat guns are recommended for the installation of these devices: HL2010E and CV198X with the correct
         reflector. See Application Equipment Section.


    246            sales@is-rayfast.com  |  +44(0)1793 616700
   243   244   245   246   247   248   249   250   251   252   253